DS2-M8/4 -M8/5 -M8/6
DS2 masurement system with 8 analogue channels

The MBOX DS2-M8/X is a measurement system for analogue voltage, which can operate standalone or with other equipment, configuration provided.

The MBOX DS2-M8/X has eight seperate input channels, e.G. DS2-sensors.

On the frontside there are eight input plugs. Six (four, five) plugs with 3 poles, can supply DC +5V for sensors.
The other two (three, four) plugs have 5 poles and have two sensor-powers of DC 5V and DC 12V.

The input channels 1-6 (1-4, 1-5) are high-impedance or can be adjusted up to DC +5V over pullup resistors of 2kOhm via the software.

The analogue data are passing a 65Hz filter and an operational amplifier until reaching the AD
converter. Then they will be computed in the processor electronic and obtained via CAN bus.

The offset calibration of the sensors is done by push button on the backside or by software.

A special configuration software, running on PCs, is necessary to configurate the MBOX.
It is possible to choose e.g. the CAN Identifier, pullup resistor or offset calibration.

See also datasheet.

DS2-M8/5

• Power IN (DC):
• Channels:
• Analog IN:
• CAN:
• USB:
• Operation temperature:
• Storage temperature:
• Ambient humidity:
• PC-Software:

• 10 ... 50V
• 8
• +-10V
• up to 1Mbaud, standard oder extended IDs, termination with Switch
• 1.1 and 2.0
• -20°C to +70°C
• -25°C to +95°C
• 0% to 95% (non condensing)
• for configuration

• Power-, CAN-, USB-Cable
• Software
  

• 186x90x52 (mm)

• DS2-M8/6:

• M-Box with 8 channels (6x red and 2x yellow)

• DS2-M8/5:

• M-Box with 8 channels (5x red and 3x yellow)

• DS2-M8/4:

• M-Box with 8 channels (4x red and 4x yellow)

For further information please contact Gi-Electronic.
All data without guarantee, technical subject to change.

TSV5-M8 -M8/2
Temperature measurement system with 4/8 channels

Measure of temperature or low analog signals
with 8 channels as short M-Box

TSV5-M8 -M8/2: Measure of temperature with K-Type sensors.
Can also be used for analogue voltages.

See also datasheet.

• Power IN (DC):
• Channels:
• Analog IN:
• -
• -
• CAN:
• USB:
• Operating temperature:
• Storage temperature:
• Ambient humidity:
• PC-Software:

• 10 ... 50V
• 8
• K-Type (Ni-Cr-Ni) -100..>1000°C
• +-200uV,+-0,2mV,+-20mV, +-200mV
• isolated channels >200V
• up to 1Mbaud, standard oder extended IDs, termination with Switch
• 1.1 and 2.0
• -20°C to +70°C
• -40°C to +95°C
• 0% to 95% (non condensing)
• for configuration

• Power-, CAN-, USB-Cables 
• Software

• TSV5-M8 :
• TSV5-M8/2 :

• 102x110x35 (mm)
• 102x110x35 (mm)

• TSV5-M8:
• TSV5-M8/2:

• M-Box with 2x converters, update rate 0.7 seconds
  
• M-Box with 1x converter, update rate 1.4 seconds
  

For further information please contact Gi-Electronic.
All data without guarantee, technical subject to change.

TSV5P4
Temperature sensor amplifier plugin-board

The TSV plugin-board has four temperature output channels for NiCrNi sensors.

This piggy-back unit is built in as standard in any ACW-Lite box and is always included.

• Temperature input:
• Sensor connector:
• Temperatue measure area:
• Resolution:
• Measure rate:

• 4 channels, galvanic seperated
  
• NiCrNi-Sensor
• -100 .... +960°C
• 0,1°C at -100 .... +960°C
• 1/sec

For further information please contact Gi-Electronic.
All data without guarantee, technical subject to change.

L3PB-DMS
Piggy-board for DMS-sensors

The L3PB-DMS-piggy utilizes 4 input channels for differential inputs (+IN and -IN) for passive pressure-sensors, like e.g. strain gage- (DMS-) sensors from e.g. Kulite or IST.

This Piggy-Back is an option for the ACW-Lite Box.

For identification, the ports are merked with a black colored ring.

• Bridge voltage:
• Sensorport:
• Ring color:
• Amplification:
• Filter:
• Compensation:

• 2V / 4V / 5V / 10V (depending on the base system)
• 4 LEMOSA Ports 4plug, EPG.0B.304.HLNS
• black
• Factor: x1 / x2 / x4 / x8 / x10 / x20 / x40 .... x4000 /x8000
• 50Hz / 65Hz / 200Hz / unfiltered
• Offset

For further information please contact Gi-Electronic.
All data without guarantee, technical subject to change.